HPC/Network Access/PuTTY Configuration/The Carbon login nodes: Difference between revisions

Revision as of 21:54, August 29, 2012

In the main PuTTY Configuration window, click Session at the top of the tree on the left.
Select the Mega session and push Load. This session will be the basis for the next steps.
Click "+" in front of SSH in the tree.
Click "SSH itself.
Uncheck the checkbox Don't start a shell or command at all.
Click Tunnels.
- Select each entry and push Remove. Since we cloned the Mega session, there might be one entry with L33301. No forwarded ports should remain at this point.
Click X11 in the tree.
- Click the checkbox Enable X11 forwarding.
- Set X display location to :0
Scroll to the top of the tree and click Session. Enter the host details:
- Host name: localhost
- Port: 33301 (referring to the tunnel set up above as L33301.)
- Protocol: SSH (leave at the default).
- In the Saved Sessions field, enter Clogin
- Push Save. The entry will appear in the list of saved sessions.

In the main PuTTY Configuration window, click Session at the top of the tree on the left.
Select the Clogin session and push Load.
Click "+" in front of SSH in the tree.
Click Tunnels.
Under Add new forwarded port, enter:
- Source port: 6200
- Destination: mgmt03:6200
- Push the Add button.
Repeat with the following settings:
- Source port: 6201 (not 6200!)
- Destination: mgmt04:6200
- Push the Add button.
- You should now see these two entries:
L6200 mgmt03:6200

L6201 mgmt04:6200

@@ Line 7: / Line 7: @@
 # '''Uncheck''' the checkbox '''Don't start a shell or command at all'''.
 # Click Tunnels.
-#* Select the '''L33301''' entry and push Remove. There should be no forwarded ports listed.
+#* Select each entry and push Remove. Since we cloned the Mega session, there might be one entry with  L33301. No forwarded ports should remain at this point.
 #: [[Image:HPC 2012-08 PuTTY config 5 tunnels remove.png]][[Image:HPC 2012-08 PuTTY config 6 tunnels clean.png]]
 # Click X11 in the tree.