Run procedures

start DAQ

this is how you start the daq,

• first you do this
• then you do that
• and then it crashes
• and then you call Mike

Good instructions makes things easy, that is why we have none.

stop DAQ

write your instructions here

Changing gain in Phill's signal box

write your instructions here

Linking two or more systems

write your instructions here

syncing two systems

For DGS

• Goto trig0 window.
• Turn off SYNC U - listed under LRU Control
• Make sure receive/send power is on for L & U

Note: If SYNC U is turned off - an Impeartive sync by DGS will reset the master clock on DFMA.

For DFMA

• Goto Trig0 Window
• Under Misc Control - turn on both undefined buttons
• Pull up diagnotsitc window on trig0.
• Set Clrk Source to LINK
• Set Nim1 and Nim2 out on master trigger module FMA

Note: Clock Source cannot be set to LINK in GUI. Set address 0x8D0 in slot 0 to set 1 for trigger modules. This needs to be fixed in Driver by Tim.

receivers

write your instructions here

cables

write your instructions here

changing FPGA Firmware code

write your instructions here